| About |
|---|
| Product Description | |
|---|---|
| Generic | PET |
| Material Status | Commercial: Active |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | |||
| — | 1.58 | g/cm³ | ASTM D-792 |
| Water absorption rate | |||
| 23℃，24hr | 0.3 | % | ASTM D-570 |
| Linear molding shrinkage rate | |||
| Flow,3.2mm | 0.4-1.0 | % | ASTM D-955 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Drying temperature/time | |||
| — | 130/3-5 | ℃/hr | — |
| Injection molding temperature range | |||
| — | 235-275 | ℃ | — |
| Injection molding reference mold temperature | |||
| — | 80-120 | ℃ | — |
| Hot deformation temperature | |||
| 1.82MPa | 220 | ℃ | ASTM D-648 |
| FLAME CHARACTERISTICS | |||
| UL94 | V-0 | Class | — |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| — | 152 | MPa | ASTM D-638 |
| elongation at break | |||
| — | 2.9 | % | ASTM D-638 |
| bending strength | |||
| 6.4mm | 198 | MPa | ASTM D-790 |
| Bending modulus | |||
| 6.4mm | 7500 | MPa | ASTM D-790 |
| Impact strength of cantilever beam notch | |||
| 3.2mm wide | 10.5 | KJ/m² | ASTM D-256 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |