| About |
|---|
| CMET HS-690 is an Epoxy; Epoxide (Epoxy) material. It is available in Asia Pacific or North America for 3d printing, stereolithography.&& |
| Product Description | |
|---|---|
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.15 | g/cm³ | |
| viscosity | |||
| 25℃ | 0.69 | Pa·s | |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 47 | J/m |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 55.0 to 61.0 | ℃ |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Penetration depth | 160.0 | µm |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 82 to 85 | ||
| Tensile modulus | 2200 | MPa | |
| tensile strength | 65.0 | MPa | |
| Tensile strain | |||
| fracture | 5.0 to 6.0 | % | |
| Bending modulus | 2450 | MPa | |
| bending strength | 80.0 | MPa |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |