About |
---|
A heavy-duty, premium floor patching system (includes primer) Intended Use: Used to repair concrete in chemical environments where heavy concentrations of acids, alkalais, and hydrocarbons are destroying the floor. Ideal for rebuilding floors around acid dip tanks, pump pads, and secondary containment areas. Product features: Trowelable to a non-porous finish 9000 psi compression strength Superior adhesion to cured concrete Non-sag formulation Outstanding resistance to acids, alkalis, water, oils, solvents, chemicals&& |
Product Description | |
---|---|
Supplier | Devcon |
Generic | 环氧树脂 |
Material Status | Commercial: Active |
Features | Alkali resistant,Acidproof,Good bond,Grease resistance,Solvent resistance |
Availabilitys | North America |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Solid content | |||
by Volume | 100 | % |
THERMAL | Nominal value | Unit | Test method |
---|---|---|---|
Thermosetting components | |||
resin | 按重量计算的混合比: 2.0 | ||
Hardening method | 按重量计算的混合比: 1.0 | ||
storage stability | |||
24 ℃ | 60 | min |
Supplementary information | Nominal value | Unit | Test method |
---|---|---|---|
Heat resistant temperature | |||
Dry | 121 | ℃ | |
Wet | 49 | ℃ |
Uncured Properties | Nominal value | Unit | Test method |
---|---|---|---|
Curing time | |||
24℃ | 16 | hr |
MECHANICAL | Nominal value | Unit | Test method |
---|---|---|---|
Shore hardness | |||
Shaw’s D | 95 | ASTM D2240 | |
compressive strength | 62.1 | MPa | ASTM D695 |
Notes |
---|
1. Typical properties: these are not to be construed as specifications. |
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |