ESTALENE EN 10 SSC

About
Estalene EN is a compounds range formulated to be used for the injection or extrusion molding of synthetic corks and it is made without SIS, SBS, SEBS rubbers. Estalene EN is patented by Cossa Polimeri. The elastic behavior of Estalene EN is obtained with a belnd of modified polyolefins. The product is studied in order to imitate the aspects of natural cork also in its superficial defects. To have the best performances we suggest the use of Estalene EN matched with an expanding agent (i.e. Estafoam 13 STO) that allows to obtain cells extrememly compact and very well distributed. The cork made of Estalene EN are equivalent to the traditional ones, concerning weight, functional and aesthetic aspects. The raw material used to produce Estalene EN are suitable for food contact. Estalene EN is certified according to FDA standards.&&

About

Estalene EN is a compounds range formulated to be used for the injection or extrusion molding of synthetic corks and it is made without SIS, SBS, SEBS rubbers. Estalene EN is patented by Cossa Polimeri. The elastic behavior of Estalene EN is obtained with a belnd of modified polyolefins. The product is studied in order to imitate the aspects of natural cork also in its superficial defects. To have the best performances we suggest the use of Estalene EN matched with an expanding agent (i.e. Estafoam 13 STO) that allows to obtain cells extrememly compact and very well distributed. The cork made of Estalene EN are equivalent to the traditional ones, concerning weight, functional and aesthetic aspects. The raw material used to produce Estalene EN are suitable for food contact. Estalene EN is certified according to FDA standards.&&

Product Description
Generic	聚烯烃，共挤薄膜用聚烯烃
Material Status	Commercial: Active
Features	High elastic,Food contact compliance
Availabilitys	Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.920 to 0.940	g/cm³	ASTM D792
Melt Flow Rate
190℃，2.16kg	9.0 to 13	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength
fracture	> 6.00	MPa	ASTM D638
Tensile strain
fracture	> 500	%	ASTM D638

Process Conditions
injection	Nominal value	Unit	Test method
Hopper temperature	140 to 150	°C
Barrel rear temperature	145 to 155	°C
Barrel middle temperature	150 to 160	°C
Barrel front temperature	155 to 165	°C
Processing (melt) temperature	145 to 165	°C
Mold temperature	20 to 40	°C

Notes
1. Typical properties: these are not to be construed as specifications.
2. 23°C
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.