LTM® 13 - SOLIAO

About
LTM® prepregs are proprietary low temperature cure, epoxide based resin systems that may be post-cured to produce high temperature composite tools. LTM13 compliments the LTM10 series by offering a cost effective mould tooling system with a low temperature, 30°C (86°F), initial cure capability and a final end use temperature after suitable post-cure of 180°C (356°F).&&

Product Description
Supplier	Cytec Industries
Generic	环氧树脂
Material Status	Commercial: Active
Features	Low CLTE,Good heat aging resistance,Low contractility,High Heat Resistance
Availabilitys	North America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Shrinkage rate
—	0.050	%
—	0.12	%

THERMAL	Nominal value	Unit
Glass transition temperature	180	℃
Linear coefficient of thermal expansion
MD
—	2.0E-6 to 3.0E-6	cm/cm/℃
—	1.0E-5 to 1.2E-5	cm/cm/℃

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.