SCHULAREC PC/ABS 42/01

About
Recycled PC/ABS produced from Post Industrial sources. PC/ABS 42/01 is suitable for injection moulding applications.&&

Product Description
Supplier	LyondellBasell
Generic	PC+ABS
Material Status	Commercial: Active
Availabilitys	Africa & Middle East ,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.14	g/cm³	ISO 1183
Melt Flow Rate
260℃，5.0kg	20 to 30	g/10min	ISO 1133
Shrinkage rate	0.40 to 0.70	%

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	2200	MPa	ISO 527-2
tensile strength
yield	50.0	MPa	ISO 527-2

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength	25 to 35	kJ/m²	ISO 179
Impact strength of cantilever beam notch	25	kJ/m²	ISO 180

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp
B50	110 to 125	℃	ISO 306

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	100 to 110	°C
Drying time	4.0	hr
Recommended maximum moisture content	0.020	%
Proposed maximum recycled material ratio	20	%
Processing (melt) temperature	260 to 280	°C
Mold temperature	70 to 100	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.