| About |
|---|
| The FR/AP Series is your material solution for applications requiring high flame retardance. The compounds are halogen free and available in natural and black colors. Typical applications Cable clips Cable holders Electric and electronic components Seals for switch boxes Material advantages Easy coloring (compounds in natural colors) Excellent mechanical properties Halogen free (reduction of toxic fire gases) Self-extinguishing, no dripping of flaming particles UL 94-V0 (3mm) listed&& |
| Product Description | |
|---|---|
| Supplier | KRAIBURG |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Halogen free,Flame Characteristics,Self-extinguishing,Good coloring,V-0 |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.13 | g/cm³ | ISO 1183 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 39 | ISO 7619 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 1.70 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 520 | % | ISO 37 |
| tear strength | 12 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 10 | % | ISO 815 |
| 70℃，24 hr | 54 | % | ISO 815 |
| 100℃，24 hr | 94 | % | ISO 815 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 3.00 mm | V-0 | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 4.0 | hr | |
| Recommended maximum moisture content | 0.020 | % | |
| Barrel rear temperature | 180 | °C | |
| Barrel middle temperature | 200 | °C | |
| Barrel front temperature | 220 | °C | |
| Mold temperature | 25 to 40 | °C | |
| Injection pressure | 20.0 to 100 | MPa | |
| Back pressure | 2.00 to 10.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type S2, 7.9 in/min |
| 3. Method Bb, Angle (Nicked) |
| 4. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |