| About |
|---|
| The FC/CS Series is your material solution for applications with food contact providing an excellent compression set. The series is available in translucent colors. Typical applications Closures Flexible Connections Household articles Membranes Packaging (for food and careproducts) Seals Valves Material advantages Adhesion to PP Applications with food contact Code of Federal Regulations, Title 21 (CFR 21) “FDA” Easy coloring (compounds in natural colors) EN71/3 Excellent mechanical properties For injection molding and extrusion High elasticity Perfect surface finish Recyclable Regulation (EU) No. 10/2011 Service temperature: -40°C to+120°C (dynamic stress: up to 100°C)&& |
| Product Description | |
|---|---|
| Supplier | KRAIBURG |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Good surface appearance,High elastic,Renewable resources,Food contact compliance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.890 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 11.0 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 850 | % | ISO 37 |
| tear strength | 17 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 23 | % | ISO 815 |
| 70℃，24 hr | 38 | % | ISO 815 |
| 100℃，24 hr | 48 | % | ISO 815 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 54 | ISO 7619 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 60 to 80 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Barrel 1 zone temperature | 160 | °C | |
| Barrel 2 zone temperature | 180 | °C | |
| Barrel 3 zone temperature | 200 | °C | |
| Nozzle temperature | 200 to 230 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type S2, 7.9 in/min |
| 3. Method Bb, Angle (Nicked) |
| 4. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |